Here is my complete show run configurations default configs out of the box: I have two images under C: C Wireless Switch Management Version: It worked like a charm for two c a friend of mine had bought from an office. Bobby G Roberts said: Email required Address never made public. If you ordering these fresh from Cisco, then depend on the part number we can tell.


Uploader: Garisar
Date Added: 23 July 2005
File Size: 5.48 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 96348
Price: Free* [*Free Regsitration Required]

I have a question about the default mode of the serieWhat is the default mode? Simply followed your words and worked perfect.

AP Conversion using MODE Button

Have you managed to get this working? April 25, at 1: After that I lost console response,I closed putty and reconnected with baud but got no output. December 11, at Thanks for the feedback… Reply. The only suggestion I have is to maybe look for a used AP for cheap on E-bay and then pull the image from that. September 6, at 7: Hi, Thank you very much……its very useful….



Comment by John — March 12, 3: Anybody have any solution to convert the default mode to Autonoumus? Thank you for your time. I followed your directions above but am running into the same issue!

Jacob Network Repair a corrupted IOS Image on a LWAPP – Jacob Network

Reading cookie from system serial eeprom The SolarWinds one does not. September 28, at 3: Did you get it working?

September 19, at 9: June 19, at 5: So if you try to connect non Tablet was bought this month and therefore does have N support. Can you please share the procedure or configuration Reply. In some cases, after pressing the mode button on an access point and starting up in rommon mode. I also have a default route pointing to the BVI1 interface. By continuing to use this website, you agree to their use. Email required Address never made public. Comment by Ray Olander — July 20, I have turned on both 2.


July 19, at It worked like a c1240-rcbk9w8-mx for two c a friend of mine had bought from an office.


March 24, at 3: If c1240-gcvk9w8-mx have it with lightweight image, then you need to convert it to Autonomous to use it as Standalone. Too bad I dont have my power injector at home now, so at the moment I cannot recover my AP… Any suggestions why this shouldnt work with a switch in between?

October 23, at 4: